Mulch vs Gravel for Garden Paths: Which Is Better?
A 3x50 foot path (150 square feet) needs 1.4 tons of gravel at 2 inches, or 1.39 cubic yards of mulch at 3 inches. This Old House builds a gravel path on a 4 inch trench with about 2.5 inches of compacted stone, fabric and edging, with the gravel 1/2 inch below the edge. Gravel lasts longer, and mulch is cheaper and breaks down.
Two materials, two jobs
Gravel and mulch both make a garden path, but they behave differently. Gravel is stone, so it lasts and drains and is heavy, and it is bought by the ton. Mulch is organic, so it is soft underfoot and cheap, and it breaks down, and it is bought by the cubic yard or the bag. The gravel calculator and the mulch calculator size each.
How a gravel path is built
This Old House's budget gravel path starts by removing the soil within the path's border to a depth of 4 inches. It lines the trench with roughly 2.5 inches of crushed stone pack, rakes it level and compacts it with a hand tamper, then lays landscape fabric over the base and sets steel edging. The gravel fills to about 1/2 inch below the top of the edging, and the article says a path 3 to 4 feet wide is typical. The article gives no thickness for the top layer, only the fill line, which is why the calculator asks you for a depth.
Worked example: a 3 x 50 foot path
The path covers 150 square feet. A 2 inch layer of crushed stone (the calculator's default, 1.4 tons per cubic yard) needs 1.0 cubic yards, or 1.4 tons with 10 percent for compaction. A 3 inch layer needs 2.1 tons and a 4 inch layer 2.9 tons. With pea gravel at 1.35 tons per yard, the 2 inch layer is 1.4 tons. One ton covers about 105 square feet at 2 inches.
Mulch is lighter. A 3 inch layer of mulch on the same path is 1.39 cubic yards, or 19 bags of 2 cubic feet. At 2 inches it is 0.93 cubic yards, and at 4 inches 1.85. Iowa State University Extension recommends a layer of 3 to 4 inches of wood chips or shredded bark on well-drained sites around trees and shrubs and 2 to 3 inches on heavy soils, and the mulch calculator suggests 2 to 3 inches for beds and 3 to 4 inches for play areas, so use that range for a path as well.
Cost: bulk or bag, gravel or mulch
At the calculators' placeholder prices of $35 per ton of gravel, $38 per cubic yard of bulk mulch and $4.50 per 2 cubic foot bag, the 3 x 50 foot path costs about $50 in gravel at 2 inches, $53 in bulk mulch at 3 inches, or $86 in bagged mulch. Those prices are only placeholders, so put in your local quotes. Mulch is often cheaper to buy, while gravel tends to need less replacing, because mulch breaks down and needs more added.
Upkeep
This Old House's gravel path maintenance list is to check and repair the edging, rake periodically and top up gravel as needed, clear leaves and debris, loosen a compacted surface with a rake and add fresh gravel, rake stray stones back on the path, and pull weeds by hand. Mulch needs the same weeding and raking, plus topping up as it decomposes. A fabric layer under either material helps block weeds, as long as it stays intact and uncovered by soil.
Edging and fabric
This Old House lays landscape fabric over the compacted base and holds it taut with spikes or pins, and makes relief cuts on both edges where the path curves so the fabric lies flat. It uses galvanized steel edging, which bends around curves, tapped into place through the fabric with a wood block rather than hammered directly, since hammering the steel can damage its zinc coating. Edging keeps both gravel and mulch on the path, so budget for it in either case.
Slope and drainage
Water runs downhill and carries loose material with it. On a sloping path, keep the top layer thin and deep enough to stay put, and consider steps or a gravel with a coarser grade. The trench in the This Old House build is kept at a consistent depth so low spots do not collect water. A path that holds water will grow weeds and rot mulch quickly.
Which should you choose?
- Choose gravel for a path you want to last, in a spot that drains, and where you can live with loose stone underfoot and the weight of the delivery.
- Choose mulch for a quick, soft, low-cost path through beds and woods, if you are willing to add more every year or two.
Common mistakes
- Skipping the base. A compacted base keeps a gravel path from rutting.
- No edging. Both materials migrate onto the lawn.
- Comparing ton and yard prices. Convert to the same unit first.
- Too thin a layer. Fabric shows through and weeds win.
- Ignoring slopes. Water washes loose material downhill.
What else to order
Edging, landscape fabric, stakes and a tamper complete the job. Use the square footage calculator for curved paths, and treat all quantities as planning estimates.
Calculators for this guide
Frequently asked questions
How much gravel do I need for a 3x50 foot path?
A 2 inch layer of crushed stone takes 1.0 cubic yards, or 1.4 tons with 10 percent for compaction. A 3 inch layer takes 2.1 tons.
How deep should mulch be on a path?
Iowa State University Extension recommends 3 to 4 inches of wood chips or shredded bark on well-drained sites around trees and shrubs, and 2 to 3 inches on heavy soils. The mulch calculator suggests 2 to 3 inches for beds and 3 to 4 inches for play areas.
How do you build a gravel path?
This Old House excavates 4 inches, adds roughly 2.5 inches of compacted crushed stone, lays landscape fabric, sets edging and fills with gravel to about 1/2 inch below the top of the edging.
Sources and further reading
- How To Lay a Budget-Friendly Gravel Path — This Old House
- How deep should the mulch layer be around trees and shrubs? — Iowa State University Extension and Outreach
More guides
Estimates only. Always confirm quantities with your supplier or a qualified contractor before ordering, and add extra for waste and site conditions.