How Many Cubic Feet Are in a Cubic Yard?
There are exactly 27 cubic feet in a cubic yard, because a cubic yard is a cube 3 feet on each side and 3 x 3 x 3 = 27. That makes 14 two-cubic-foot bags per yard, and one cubic yard covers 108 square feet at 3 inches deep.
The answer: 27
There are 27 cubic feet in a cubic yard. This is not a rounded figure, it is exact, because a yard is defined as 3 feet and a cubic yard is a cube 3 feet long, 3 feet wide and 3 feet tall.
Why it is 27 and not 3 or 9
Lengths scale by 3, but volume scales by 3 in every direction. Hunker describes a cubic yard as the volume of a block 3 feet by 3 feet by 3 feet. Picture the base of that block: 3 x 3 = 9 square feet, which is one square yard. Stack three layers of those 9 square feet, each 1 foot tall, and you have 3 x 9 = 27 cubic feet. A square yard is 9 square feet, and a cubic yard is 27 cubic feet, and the two are easy to confuse.
The same volume in other units
NIST's conversion tables define a cubic yard as 0.7645549 cubic meters. The cubic feet to cubic yards calculator gives the same volume in several units.
- Cubic feet: 27.
- Cubic inches: 46,656 (27 x 1,728 cubic inches per cubic foot).
- Cubic meters: 0.765.
- Liters: about 765.
- US gallons: about 202.
How many bags in a cubic yard
Bagged soil, mulch and sand are labeled in cubic feet, so the number of bags in a yard is 27 divided by the bag size, rounded up to a whole bag.
| Bag size | Bags per cubic yard |
|---|---|
| 0.5 cu ft | 54 |
| 1 cu ft | 27 |
| 1.5 cu ft | 18 |
| 2 cu ft | 14 |
| 3 cu ft | 9 |
Hunker says a cubic yard of mulch takes 14 bags of 2 cubic feet each. Check the label, since not every bag is the size you expect.
How far a cubic yard goes
A cubic yard spread to a given depth covers an area, and Hunker's chart gives these coverages for mulch. The mulch calculator confirms each: the area below, at the depth shown, needs 1.00 cubic yards.
| Depth | Area covered by 1 cubic yard |
|---|---|
| 1 inch | 324 sq ft |
| 2 inches | 162 sq ft |
| 3 inches | 108 sq ft |
| 4 inches | 81 sq ft |
The pattern is that 324 square feet at 1 inch deep makes 27 cubic feet, and each extra inch divides the area by that many. Hunker's mulch chart uses exactly these numbers, and the same math applies to any loose material.
Converting a real project
Say you measure a bed at 100 cubic feet. Divide by 27 and you get 3.7 cubic yards, which matches the calculator's result for 100 cubic feet. If you have the length, width and depth, multiply them all in feet, using the depth in inches divided by 12, then divide by 27. Our cubic yard calculator does the whole chain.
Truck loads and quick mental math
Suppliers talk about loads in cubic yards, so it helps to translate. A 10 cubic yard load is 270 cubic feet, and the cubic yard calculator treats a pickup as roughly one cubic yard and a tandem dump truck as roughly ten, which are rough planning numbers that depend on the vehicle and the material. Heavy materials such as gravel or wet soil are limited by weight, not volume, so a pickup may carry well under a yard of them.
For quick mental math, divide cubic feet by 30 and add about a tenth. For 100 cubic feet that gives roughly 3.7 cubic yards, which is close to the exact 3.70. Use the exact factor of 27 whenever you place an order.
Common mistakes
- Using 9 or 3. That is for square yards or linear yards, not cubic.
- Leaving depth in inches. Divide the inches by 12 before multiplying.
- Rounding the bag count down. You cannot buy part of a bag.
- Forgetting settling. Soil and mulch compress, so order a little extra.
- Treating volume as weight. A cubic yard of gravel weighs far more than a cubic yard of mulch, and delivery is often priced by weight.
What else to consider
For a delivery, ask whether the supplier sells by the yard or by the ton, and whether the yard they quote is loose or compacted. Your planning number here is the volume, and the supplier's ticket is what counts.
Calculators for this guide
Frequently asked questions
How many cubic feet are in a cubic yard?
27 cubic feet. A cubic yard is a cube 3 feet long, 3 feet wide and 3 feet tall.
Why is a cubic yard 27 cubic feet and not 9?
Nine is the number of square feet in a square yard. A cubic yard adds a third dimension, 3 feet tall, so you multiply the 9 square feet by 3 to get 27 cubic feet.
How many cubic feet of mulch cover 100 square feet at 3 inches?
At 3 inches deep, 100 square feet needs 25 cubic feet, which is a little under one cubic yard (0.93 yards).
Sources and further reading
- NIST Guide to the SI, Appendix B.8: Factors for Units Listed Alphabetically — National Institute of Standards and Technology
- How Much Will a Cubic Yard of Mulch Cover? — Hunker
More guides
Estimates only. Always confirm quantities with your supplier or a qualified contractor before ordering, and add extra for waste and site conditions.