Roof Pitch Explained: Rise, Run and What It Means
Roof pitch is how many inches the roof rises for every 12 inches of run, such as 6/12. A 6/12 roof is a 26.57 degree angle with an area multiplier of 1.118, so a 1,500 sq ft footprint has about 1,677 sq ft of roof. Common residential pitches run from 4/12 to 8/12, and asphalt shingles need at least 2:12.
Pitch is rise over run
This Old House defines pitch as how many inches your roof rises vertically for every 12 inches it runs horizontally, written as a fraction such as 6/12. IKO's slope guide uses the same idea, with slope written as rise : 12, so that 4 inches of rise over 12 inches of run is 4:12. Roofers say "six twelve" for a 6/12 roof. The number tells you how steep the roof is, and it feeds into how much roofing you buy.
Common pitches
This Old House says the most common residential pitches are typically between 4/12 and 8/12. A 4/12 roof is a lower slope often seen on ranch-style and contemporary houses, 6/12 is one of the most common choices, and 8/12 is a steeper design that performs well in heavy rain or snow. The steepest pitch commonly used on homes is 18/12, which is a 60 degree angle.
Pitch, angle, slope and the area multiplier
The same roof can be described in several ways. The roof pitch calculator converts between them.
| Pitch | Angle | Slope | Area multiplier |
|---|---|---|---|
| 2/12 | 9.5° | 17% | 1.014 |
| 3/12 | 14.0° | 25% | 1.031 |
| 4/12 | 18.4° | 33% | 1.054 |
| 5/12 | 22.6° | 42% | 1.083 |
| 6/12 | 26.6° | 50% | 1.118 |
| 7/12 | 30.3° | 58% | 1.158 |
| 8/12 | 33.7° | 67% | 1.202 |
| 9/12 | 36.9° | 75% | 1.250 |
| 12/12 | 45.0° | 100% | 1.414 |
A 6/12 roof is a 26.57 degree angle. IKO gives the 2:12 slope as about 9.5 degrees and 4:12 as about 18.5 degrees, and the exact values are 9.5 and 18.4 degrees. The area multiplier is what turns the flat footprint under the roof into the true surface of the roof. It is the hypotenuse of the 12 inch run and the rise, divided by 12, so a 6/12 roof has a multiplier of 1.118.
roof area = footprint x multiplier
Why pitch changes how much roofing you buy
A steeper roof has more surface for the same footprint. This Old House's shingle guide uses the same factors: 1.054 at 4:12, 1.118 at 6:12 and 1.202 at 8:12, applied to the measured area of each roof plane. For a footprint of 1,500 square feet, a 4/12 roof has 1,581 square feet of surface, a 6/12 roof has 1,677, and a 9/12 roof has 1,875. The 6/12 case is 16.8 roofing squares of 100 square feet before waste. That is the number you start with when you estimate bundles of shingles.
The roofing calculator does the rest. For a 40 x 28 foot house with a 1 foot overhang and a gable roof, it gives 47 bundles at 6/12 and 50 at 8/12, including waste.
Roof shape adds waste on top of pitch
Pitch tells you the area, but the shape of the roof sets how much of the material is cut away. The roofing calculator uses a waste allowance of 10 percent for a gable roof, 12 percent for a hip roof and 15 percent for a complex roof with valleys and dormers. For the same 40 x 28 foot house at 6/12, that is 47 bundles for a gable, 48 for a hip and 49 for a complex roof. This Old House's shingle guide likewise suggests 15 percent for cuts around vents and pipes and for ridge caps, and 15 to 20 percent for complex roofs.
Pitch decides what you can use
Low slopes limit the roofing materials. IKO calls 2:12 the traditional absolute minimum slope for asphalt shingles, notes that some shingles require a higher minimum, and says 4:12 is most commonly considered the lowest slope for standard installations. It classes slopes from 2:12 to 4:12 as low slope, and 0:12 to 2:12 as flat. Check the manufacturer's installation instructions and local code for your product, because low-slope installations can have extra requirements.
Pitch is not the same as slope in the strict sense
The two words are used interchangeably in practice. This Old House notes that, technically, slope considers rise and run, while pitch uses the full horizontal span. IKO makes the same point and says the technical definition of pitch differs, but uses rise over run for slope. For ordering shingles you only need the rise per 12 inches, which is what roofers call the pitch.
Common mistakes
- Using the footprint as the roof area. A pitched roof is always bigger.
- Confusing degrees with pitch. A 6/12 roof is not 6 degrees but about 26.6 degrees.
- Forgetting overhangs. The eaves add to the footprint.
- Ignoring minimum slope. Some roofing needs a steeper pitch.
- Skipping waste. Hips, valleys and cuts need extra material.
What to do next
To find your own roof's pitch, measure rise over 12 inches of run with a level, or read it from the attic side. Then enter the pitch into the roofing calculator, and treat the estimate as a planning number.
Calculators for this guide
Frequently asked questions
What does a 6/12 roof pitch mean?
The roof rises 6 inches for every 12 inches it runs horizontally. That is a 26.57 degree angle, a 50 percent slope and an area multiplier of 1.118.
What is the most common roof pitch?
This Old House says typical residential pitches are between 4/12 and 8/12, with 6/12 one of the most common.
What is the minimum roof pitch for asphalt shingles?
IKO says 2:12 has traditionally been considered the absolute minimum for asphalt shingles, that some shingles require a higher minimum, and that 4:12 is the most common lowest slope for standard installation.
Sources and further reading
- What Are the Most Common Roof Pitches? — This Old House
- Minimum Slope for an Asphalt Shingle Roof — IKO
- Roof Shingles Calculator: How To Find the Right Amount — This Old House
More guides
Estimates only. Always confirm quantities with your supplier or a qualified contractor before ordering, and add extra for waste and site conditions.