How Much Sand Do You Need for Your Project?
Multiply length x width x depth in feet, then divide by 27 to get cubic yards. A 12x12 foot patio needs 0.49 cubic yards of bedding sand at 1 inch, about 0.64 tons, and a 4x4 foot sandbox at 8 inches needs 0.43, with 10 percent extra. Wet sand weighs more than dry.
Start with volume in cubic yards
Bulk sand is sold by the cubic yard or by the ton, so the first job is volume. Multiply length by width by depth, with the depth in feet, and divide by 27 cubic feet per cubic yard. Then add an allowance for settling and spillage.
order = cubic yards x (1 + extra %)
The sand calculator does this for the common jobs and also converts to tons and 50-pound bags. Use the cubic yard calculator if you are converting between cubic feet, yards and truck loads.
How much sand for common projects
The table uses a 10 percent allowance and dry sand at 1.3 tons per cubic yard, which is the calculator's setting for dry sand.
| Project | Size | Depth | Cubic yards | Tons |
|---|---|---|---|---|
| Paver bedding, patio | 12 x 12 ft | 1 in | 0.49 | 0.64 |
| Sandbox | 4 x 4 ft | 8 in | 0.43 | 0.56 |
| Sandbox | 8 x 8 ft | 8 in | 1.74 | 2.26 |
| Leveling / topdressing, lawn patch | 10 x 10 ft | 2 in | 0.68 | 0.88 |
| Play area | 10 x 10 ft | 12 in | 4.07 | 5.30 |
Paver bedding sand
Unilock's paver base guide specifies a bedding layer 1 inch thick, spread over the compacted base with pipe guides and a straight board. A 12 x 12 foot patio at 1 inch is 12.0 cubic feet before any allowance, and 0.49 cubic yards with 10 percent extra. That is 0.64 tons of dry sand, or 26 bags of 50 pounds. Beyond the bedding, you also need joint sand. CMHA's installation FAQ says to use ASTM C144 mason sand or polymeric sand for the joints, and that ASTM C33 concrete sand may be used but is harder to work into the joints.
Sandbox sand
A 4 x 4 foot sandbox filled 8 inches deep holds 0.40 cubic yards. With 10 percent extra the order is 0.43 cubic yards, about 0.56 tons of dry sand or 23 bags of 50 pounds. A larger 8 x 8 foot box at the same depth takes 1.74 cubic yards, 2.26 tons, or 91 bags.
If the sand is part of play equipment rather than a ground-level box, use the deeper numbers. NDSU Extension's playground guide, which reprints the Consumer Product Safety Commission's table, lists sand at a minimum compressed depth of 9 inches, protecting against falls from up to 4 feet. The same guide quotes the CPSC checklist question about having at least 12 inches of loose fill, as recommended. Use the 12 inch option in the calculator for a play area, and keep it topped up as it compacts.
Weight changes with moisture
Yards and tons are not interchangeable, because wet sand is heavier. The calculator uses 1.3 tons per cubic yard for dry sand, 1.4 for damp and 1.6 for wet, and these are planning assumptions, not measured values. For the 4 x 4 foot sandbox with 10 percent extra, that is 0.56 tons dry, 0.61 tons damp and 0.69 tons wet. Delivered sand is often damp, so ask the yard whether they sell by the ton or by the yard and what their sand weighs.
Bags or bulk?
A 50 pound bag holds only a small fraction of a cubic yard, so bags make sense for small jobs. The 4 x 4 foot sandbox is 23 bags, which is manageable. The 12 x 12 foot patio bedding is 26 bags, which is a lot of lifting. As a rule of thumb, once you are past a couple of hundred pounds of sand, compare the delivered bulk price with the bag price, and check whether the yard has a minimum delivery.
Common mistakes
- Using the wrong sand. Paver bedding, joint sand and play sand are different products, so tell the supplier what the sand is for.
- Ordering the exact volume. Sand compacts and spills, so add around 10 percent.
- Mixing up yards and tons. Check which unit your supplier quotes before comparing prices.
- Ignoring moisture. Wet sand can weigh noticeably more than dry sand for the same volume.
- Using bedding sand as a base. The 1 inch bedding layer sits on a compacted aggregate base, so order gravel separately.
What else to order
For a patio, add the gravel base and edge restraint, and size the base with the gravel calculator. For a sandbox, consider a cover so animals stay out. Treat these figures as planning estimates.
Calculators for this guide
Frequently asked questions
How many bags of sand are in a cubic yard?
At 1.3 tons per cubic yard of dry sand, a cubic yard is about 52 bags of 50 pounds. The calculator's weights are planning assumptions, so confirm with your supplier.
How much sand do I need for a 4x4 sandbox?
At 8 inches deep that is 0.40 cubic yards, or 0.43 cubic yards with 10 percent extra. In weight that is about 0.56 tons of dry sand, or 23 bags of 50 pounds.
How thick should paver bedding sand be?
Unilock's paver base guide specifies a bedding layer 1 inch thick, laid over the compacted gravel base. A 12x12 foot patio at that depth needs about 0.49 cubic yards with 10 percent extra.
Sources and further reading
- Paver Base Specifications — Unilock
- Installing Standard Interlocking Concrete Pavers on Open-Graded Aggregates (PAV-FAQ-002) — Concrete Masonry & Hardscapes Association
- Is Your Playground Safe for Kids? (FN1374) — NDSU Extension
More guides
Estimates only. Always confirm quantities with your supplier or a qualified contractor before ordering, and add extra for waste and site conditions.